Quadro Quadro4x Przewodnik Instalacji Pobierz pdf (Strona 11)

QuadroE1/T1 Manual-I: Installation Guide Configuring the QuadroE1/T1

Configuring the QuadroE1/T1

Configuring the QuadroE1/T1 basically, three steps are needed:

Step1: Basic Configuration using the Basic Configuration Wizard

Step 2: Entering the E1/T1 settings provided by your PSTN Provider

Step 3: Specifying the Call Routing paths according to your dial plan

Basic Configuration

The most important settings required are:

• Static IP address for the WAN Interface. If you use a DHCP server, please

configure it to deliver a static IP address. In this case, QuadroE1/T1 will get its

IP address automatically, as it acts as a DHCP client on the WAN side.

• Bandwidth - to regulate the number of calls allowed by the QuadroE1/T1 to

avoid degradation in low bandwidth conditions.

• Time/Date - to ensure the correct time and time zone is used for call records

• Regional Settings - if your QuadroE1/T1 is located outside the United States, it

is important to properly configure your line connections to the PSTN in your loca-

• r configure the fire-

wall to make the QuadroE1/T1 accessible for management.

and complete the

imple Basic Configuration as described in the following two sections.

tion

Firewall - if your QuadroE1/T1 is connected behind a route

To customize settings, connect a PC to QuadroE1/T1's LAN port, log in

QuadroE1/T1; (SW Version 2.4.x) 10

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 40 41

Brak uwag

Quadro Quadro4x Przewodnik Instalacji Strona 11