Quadro Quadro16xi Przewodnik Instalacji Pobierz pdf (Strona 81)

Quadro Manual II: Administrator's Guide Administrator’s Menus

Quadro2x, 2xi, Quadro4x, 4xi, Quadro16x, 16xi; (SW Version 5.2.x) 80

Line Settings

The Line Settings are used to configure Quadro FXS and IP Line (if available on the board) settings. The Line Settings page consists of two pages:

Onboard Line Settings page for onboard FXS lines configuration and IP Line Settings for IP Lines configuration.

Onboard Line Settings

The Onboard Line Settings page is used to configure Quadro lines and to define the caller ID detection type, configure remote party disconnect

indication and select the ringer type on each of them. Additionally this page provides an option to enable Loopback diagnostics on the lines.

The Onboard Line Settings page shows the table Available

Lines where all active lines of Quadro are listed with their

Attached Extension. If the line is attached to an extension, the

corresponding extension number is displayed in this column;

otherwise “none” is displayed if the extension is not attached to the

line. By clicking on the extension number, the Extensions

Management

– General Settings page will appear, where the line

attached to the extension can be reconfigured. Additionally, the

table provides information about the selected Ringer Type and

Caller ID detection method that is configured for the selected line.

The caller ID detection method is different for various types of

phones and can be found in the phone manual.

The Loopback Settings link takes you to the page where lines

can be configured for loopback diagnostics purposes.

Fig. II-141: Line Settings Page

When pressing on the line number under the Available Lines column

, the Onboard Line Settings page specific for the current line is opened and

offers the following input options:

The Caller ID drop down list contains various standards of Caller

ID transmissions. It is used to send the calling party's information

to the phone attached to the selected line:

• No Caller ID.

• FSK, send prior to the first ring.

• FSK, send between the first and second ring.

• FSK, send both prior to a ring and between the first

and second ring.

• DTMF, send prior to the first ring.

• DTMF, send between the first and the second ring.

• Combined, send both DTMF prior to the first ring and

FSK between the first and the second rings.

Quadro sends the current time/date to the called phone together

with the caller’s information.

A group of Remote Party Disconnect Indication parameters are

used to configure the private PBX attached to the Quadro FXS

port.

• The Enable Busy Tone Indication checkbox enables a

busy tone transmission to the FXS port when the remote

party being called is disconnected. The Busy Tone

Duration drop down list is used to select the period (in

seconds) when a busy tone will be transmitted to the FXS

port.

• The Enable Power Disconnect Indication checkbox

enables the power cycling on the FXS line when the

remote party being called is disconnected. Power

Disconnect is applied after the busy tone transmission on

the FXS line. The Disconnect Duration drop down list is

used to select the period (in milliseconds) when the FXS

line power will be down.

Fig. II-142: Line Codec and Caller ID Settings page

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 149 150

Komentarze do niniejszej Instrukcji

Brak uwag

Quadro Quadro16xi Przewodnik Instalacji Strona 81

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy Premise Branch Exchange (PBX) Quadro Quadro16xi